Important Information - Camo DRIVE Manual Del Propietário

IMPORTANT INFORMATION

TERMINOLOGY
The following terms will apply interchangeably throughout this Owner's Manual:
Driver Drill / the Drill
Attachment / CAMO DRIVE
®
Tool – refers to CAMO ® DRIVE
PERSONAL SAFETY ITEMS
• Do not use the Tool and/or components prior to reading the CAMO
• Always wear eye protection that conforms to ANSI requirements (Z87.1) and provides protection against flying particles
both from the front and side. Eye protection should be worn by the operator and by others in the work area. Eye
protection is required to protect against flying fasteners and debris that could possibly cause severe eye injury.
• The user is responsible to enforce the use of eye protection equipment by the Tool operator and all other personnel in the
work area.
• To prevent accidental injuries: Handle the Tool and components with care - Always assume that the Tool contains
fasteners - Always disconnect the power from the Driver Drill when:
• Loading CAMO
• Performing inspection, maintenance or repair
• Clearing a screw jam
• The Tool is not in use
• Leaving the work area
• Moving the Tool to another work location
• Handing the Tool to another person
• Storing the Tool - To reduce the risk of electric shock and damage to the Tool, never immerse the Tool in liquid or
allow a liquid to flow inside the Tool - Never point the Tool toward yourself or anyone else - Never engage in
horseplay - Never hold or carry the Tool with a finger on the trigger of the drill. - Never place a hand or any other
part of the body in the fastener discharge area of the attachment while the power is connected.
OPERATION OF THE TOOL
• Never inspect, maintain, repair, adjust, clear a jam or store the Tool with the power connected.
• Never use the Tool in proximity of flammable gases or liquids, as some tools will create sparks that can be an ignition
source for a fire or explosion.
• Never assume the Tool is empty of fasteners.
• Never point the Tool toward yourself or any other persons.
• Never drive the Tool unless it is in contact with the work-piece.
• Never use the Tool as a hammer or wedging device or drop to the floor from any height.
• Use only CAMO ® Collated Fasteners with the DRIVE
Attachment. The DRIVE
™
™ assembled with driver drill
® Collated Fasteners for DRIVE
holds one (1) strip of 50 CAMO
™
® DRIVE ™ Owner's Manual.
™ . Never use any fasteners that are not specified for use with this
Collated Fasteners.
®
4