Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1
Product features
1 Flexible Gooseneck
2 Visual Leak indicator
3 Low Battery Indicator
4 Power On Light
5 Solid State semi-conductor sensor
6 Sensor Cover
7 Audible Leak Indicator
8 Tic Adjustment (located on the side of the unit)
9 Protective Boot
10 Gooseneck Clip
11 Socket for Optional Earphone
12 Tip Light
2
General description
This instrument is an advanced combustible gas leak detector, capable of locating many
combustible, non combustible and toxic gases.
A partial list of these gases include:
Aceton
Alcohol
Ammonia
Benzene
Butane
Ethylene
Gasoline - Petrol
Hydrogen
The detector is factory calibrated for methane in air.
3
Operation
Turn the instrument on by rotating the thumbwheel downwards in a non-contaminated
environment. i.e. Fresh Air.
The green Power LED will be illuminated when the unit is turned on. If the battery level is
low then the red LED will be steady and the tic rate will not be adjustable. The battery will
need replacing.
Adjust to a slow uniform tic rate with the use of the thumbwheel (approximately 2 ticks per
second). This sets the instrument to the background level, you should start your testing by
setting in fresh air. The red LED indicator will flash in correspondence with the tic rate.
Please allow around 10 seconds for the sensor to stabilise indicated by a steady tic rate.
However it may occasionally require up to 2 minutes to stabilise under some conditions.
The unit responds to gas with a variable audible ticking sound. The audible tic increases in
volume when exposed to gases with 50 parts per million or more. When gas is detected the
tick rate will increase, rotate the thumbwheel back to the steady tick, resetting the
instrument to this new background level. Move the instrument into higher concentrations of
gas (indicated by increased tick rate) until the leak is found.
Industrial Solvents
Jet Fuel
Lacquer Thinners
Methane
Naphtha
Natural gas
Propane
Toluene
ENGLISH
7
Capítulos
Tabla de contenido
