Connecting The Water Lines - LG WD1873RDS Manual Del Propietário

14
INSTALLATION INSTRUCTIONS

Connecting the water lines

1
Check the rubber seals on both sides of the
hose.
- Insert a rubber seal into the threaded fittings
on each hose to prevent leaking.
Rubber seal
Water hose
(To water inlet on the
washing machine)
2
Connect the water supply hoses to the HOT and
COLD water faucets tightly by hand and then
tighten another 2/3 turn with pliers.
- Connect the blue hose to a cold water faucet
and the red hose to a hot water faucet.
WARNING
y Do not overtighten. Damage to the coupling
can result.
3
After connecting inlet hose to water faucets,
turn on the water faucets to flush out foreign
substances (dirt, sand or sawdust) in the water
lines. Let water drain into a bucket, and check
the water temperature.
Rubber seal
Water hose
(To faucet)
4
Connect the hoses to the water inlets tightly
by hand and then tighten another 2/3 turn with
pliers.
- Connect the blue hose to the cold water inlet
and the red hose to the hot water inlet.
Cold
water
inlet
WARNING
y Do not overtighten the hoses. Overtightening
can damage the valves resulting in leaking and
property damage.
5
Check for leaks by turning on the faucets.
- If water leaks, check steps 1 to 4 again.
NOTE
y For your safety, and for extended product
life, use only authorized components. The
manufacturer is not responsible for product
malfunction or accidents caused by the use of
separately purchased unauthorized parts.
y Use new hoses when you install the washing
machine. Do not reuse old hoses. Use only the
inlet hoses provided with the washer. LG does
not recommend the use of aftermarket hoses.
y Periodically check the hoses for cracks, leaks
and wear, and replace the hoses every 5 years.
y Do not stretch the water hoses intentionally,
and make sure that they are not crushed by
other objects.
y Water supply pressure must be between
14.5 PSI and 145 PSI (100~1000 kPa). If the
water supply pressure is more than 116 PSI, a
pressure reducing valve must be installed.
y To provide optimum washing performance the
hot water temperature should be set at 120-
135°F (48-57°C) and the cold at 60°F (15°C).
Hot water
inlet