IO Mabe IOMN3FFH Instructivo Y Advertencias página 47

• Remove the two 5/16"or 1/8"hex headscrews, then
lift the hinge straight up to free the hinge pin.
• Open the refrigerator door to 90°.
• Lift the refrigerator door up and release it from the
bottom hinge.
• Set the door on a non-scratching surface with the
inside up.
8. Replacing the doors
To replace the doors, simply reverse steps 3 through 7.
However, please note the following:
• When lowering the doors onto the bottom hinges,
make sure the second person carefully guides the
tube and harnesses through the holes in the hinges.
• When connecting the water line, make sure you
insert the tubing all the way to the mark.
• Do not pinch the tubing and harnesses when placing
the doors on the bottom hinges.
CONNECTING THE REFRIGERATOR TO THE HOUSE
WATER LINE (ice and water dispenser models)
A cold water supply is required for automatic ice maker
and dispenser operation. If there is not a cold water
supply, you will need to provide one. See Installing the
Water Line section.
Notes:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
• If your refrigerator does not have a water filter, we
recommend installing one if your water supply has
sand or particles that could clog the flow through
the refrigerator water valve. Install it in the water line
near the refrigerator.
• If you are using copper tubing, place a compression
nut and ferrule (sleeve) onto the end of the tubing
coming from the house cold water supply. If you are
using the tubing kit, the nuts are already assembled
to the tubing.
• If you are using copper tubing, insert the end of
the tubing into the refrigerator connection, at the
back of the refrigerator, as far as possible. While
holding the tubing, tighten the fitting. If you are
using tubing kit, insert the molded end of the tubing
into the refrigerator connection, at the back of the
refrigerator, and tighten the compression nut until it
is hand tight. Then tighten one additional turn with a
wrench. Overtightening may cause leaks.
• Fasten the tubing into the clamp provided to hold it
in position. You may need to pry open the clamp.
TURN ON THE WATER SUPPLY
Turn the water on at the shut off valve (house water
supply) and check for any leaks.
47