Tabla de contenido
Idiomas disponibles
Idiomas disponibles
T
ABLE OF
Replacement Parts
1
C
ONTENTS
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
. . . . . . . . . . . .
P
C
ACKAGE
ONTENTS
1
Mini Shaker or Microplate Shaker
Non-skid rubber mat (Mini Shaker only)
1
234cm detachable power cord
2
Instruction manual
2
I
NSTALLATION
2
2
Upon receiving the VWR Mini/Microplate Shaker, check to ensure that no
damage has occurred during shipment. It is important that any damage
3
that occurred in transport is detected at the time of unpacking. If you
3
do find such damage the carrier must be notified immediately.
4
After unpacking, place the Mini/Microplate Shaker on a level bench or
5-6
table, away from explosive vapors. Secure to an immovable work surface
by pressing down on the four (4) corners of the unit, creating a strong
7-8
suction to the work surface (DO NOT place on a bench mat). Ensure that
9-10
the surface on which the unit is placed will withstand typical heat produced
10
by the unit. Always place the unit on a sturdy work surface.
11-12
The Mini/Microplate Shaker is supplied with a power cord that is inserted
13-14
into the IEC connector on the back of the unit first, then it can be
plugged into a properly grounded outlet. The 230V unit plugs into a 230
volt, 50/60 Hz source.
Capítulos
Tabla de contenido
Solución de problemas
