Aquavitro Division 125 Manual De Instrucciones página 12

Figure 3
3. ATTENTION: While the division™ skimmer is not affected by changes in water level, the
Pump (G) must never be allowed to run without being submerged. Do not run the pump
if water drops below the ~MIN~ waterline mark on the Pump (G) Figure 3. Plug in the
Pump (G) and ensure it is operating to fill the Reaction Column (C) with both water and air
bubbles.
4. Adjust the height of the Drain Tube (E) and Drain Spillway (H), see Figure 3, by turning the
threaded rod clockwise to raise the level and counterclockwise to lower the level of the
water and foam in the Reaction Column (C). The level should be adjusted so that the top of
the foam is at the highest level without overflowing. While this level will be very stable, it is
important to wait a few moments to allow for stabilization of the system as a whole.
5. Replace the Collection Cup (D).
6. Upon initial setup, it is important to check the level of the foam every couple of hours as the
new plastic components can inhibit foam production briefly.
7. Once the level in the Reactor Column (C) is fully stable, foam will begin to build and rise
up into the Collection Cup (D). Make any adjustments to the level of foam by raising or
lowering the Drain Tube (E) and Drain Spillway (H). Raise the level by turning the Threaded
Rod (E) clockwise (up), and lower the level by turning it counterclockwise (down).
12