Programming With The Easy Base Unit - Gewiss Chorus GW 10 752 Manual Del Usuario

PROGR MMING WITH THE E SY B SE UNIT
By assembling the push-button panel with the rear programming LED at the bottom, the
correspondence between the buttons and the channels during the programming with the
Easy base unit is illustrated in Figure C.
Programming the buttons through the Easy base unit (code GW 90 831).
Each button to be programmed can be selected, at choice:
• by pressing the button: the corresponding channel will be highlighted in the channel
list in the Application ¡ New function or Application ¡ Edit function menu;
• directly from the list of channels of the "Application ¡ New function" or "Application ¡
Edit function" menus.
To select the status LEDs (for edge management) select the status channels from the
"Application ¡ New function" or "Application ¡ Edit function" menus.
The correspondence between the status LEDs and the numbering of the status
channels is illustrated in Figure D.
The functions can be created after the devices have been selected.
21
E
N
G
L
I
S
H