Tabla de contenido
MAINTENANCE
The flames should look like those in Figure 11. To clean
the burner, use a soft brush after the burner has cooled
completely. Never use a vacuum cleaner on the burner. It
is recommended to store the fire pit indoors during winter
if it will be subjected to freezing temperatures. The LP
cylinder must be disconnected and removed from the
appliance before the appliance can be stored indoors.
Figure 11
LIGHTING INSTRUCTIONS
Warning: If these instructions are not followed exactly, a fire or explosion may result causing
property damage, personal injury, or loss of life.
IGNITER BUTTON
Figure 12
CONTROL KNOB
1. Read instructions before lighting.
2. Push in on the control knob and turn to the ON position.
3. With the control knob pressed in, also push the igniter button to light the burner. Release the
control knob after 15 seconds. If the burner does not light, wait 5 minutes, repeat.
4. Adjust the flame to the desired height by using the control knob. See Figure 12.
BURNER COVER ASSEMBLY
Place the burner cover on the table top as shown in
Figure13.
WARNING: BEFORE PLACING THE BURNER COVER ON,
MAKE SURE THE FIREPIT HAS BEEN SHUT OFF AND THE
BURNER HAS COMPLETELY COOLED DOWN.
Figure 13
10
Tabla de contenido
