Accessories - CUISIMAT ZUMMO ZUMMITO Z 05 Guia Del Usuario

• Remove the cover and wipe it with a damp cloth (ATENTION!: NEVER clean it with
products that can scratch it).
• The tray and blade are removed by unscrewing the nuts on the tray shafts and pulling
outwards horizontally (never extract the set throwing of the blade). Also unscrew the balls
or bevel-headed squeezers that are inside the tray that holds the squeezers (Fig. 15 &
16); underneath each one of them there should be one washer (Fig. 22), be careful not to
lose them! These pieces can be put in the washing machine or cleaned manually. TAKE
EXTRA CARE WITH THE BLADE (Fig. 3) since it is very sharp and may cause injury.
• To remove the cups we recommend that you loosen the fastening screws a little and pull
outwards; they will be released and can then be easily removed.
• WARNING! Do not was the DRIP TRAY (Ref. 0508008 DRIP) using hot water or
dishwasher at temperature over 40ºC. In case of distortion of the Drip Tray, this will not be
covered by the guarantee.
Assembly
After everything is washed, put it back in place in the following order:
1 Screw on the balls is the tray that holds the squeezers. Make sure that washers are put
in place beforehand and that the balls are properly tightened.
2 Check that the rubber bands of the blade are properly in place (Figs. 19 & 20). Insert the
blade inside the tray.
simultaneously. (Fig. 12). Never mount the blade on the tray afterwards!! When it
makes contact with the bottom, fit the projecting part of the blade into the front guide
(Fig. 13).
3 Place the cups on the shafts and tighten the fastening nuts.
4 The cover is put back in place by fitting its clasps into the slots located on both front
sides (make sure that the clasps fit correctly into the slots). (Fig. 8 y 9)
Before starting up the machine, make sure that:
•
The tray and blade have been properly fitted into place and screwed down.
•
The blade has been properly fitted into place and in the horizontal position.
•
The nuts on the cups are properly tightened.
•
The correct sets of balls and cups have been used (see the section entitled

"accessories").

In the event that the tray, balls or cups were not properly fitted into place, damage may be done
to these pieces and the inside of the machine. (Problems not covered by the guarantee since
they are errors made by the operator).
Cleaning the loader
Lift the loader up and it will come off easily, with the top of the machine remaining totally
uncovered. After cleaning it, put it back in place by fitting the legs into their respective
openings. (Fig. 14)
9
ACCESSORIES
Depending on the size of the fruit that you want to squeeze, the machine has several different
sets of cups and balls to choose from:
a Tray for holding bevel-headed squeezers, balls, and cups (green) for fruit with a
diameter between 55 – 75mm. (Fig. 15).
b Tray for holding bevel-headed squeezers, balls, and cups (red) for fruit with a
diameter between 70 – 90mm. (Fig. 16).
c (Optional). Small red cups and balls for fruit with a diameter between 45 –
60mm. (Fig. 17).
Regardless of the set used, the blade will always remain the same.
ATTENTION!: Do not mix elements of different sets together.
16
Assemble this set on the machine's three shafts