Idiomas disponibles
Idiomas disponibles
Stabilizing the Unit
To stop the tie rack from tilting, it is important to secure
the unit to the rod with the mounting screw on the
bottom of the unit.
Pull out the mounting screw grip and turn it clockwise
to tighten. Tighten only using your fingers, do not
over-tighten.
Optional Stabilizing Bar
Pull the stabilizing bar out from the rear of the unit.
Remove the snap-on latch from the bar by pinching the
two small tabs and pulling it away.
Use the screws or the adhesive provided to attach the
latch to the rear wall. Extend the bar to the wall and
connect to the latch.
The product herewith complies with the requirements of the EMC Directive 89/336/EEC
and carries the "CE" mark accordingly.
Quiet Power
CORD GUIDE TO HOLD OPTIONAL POWER
SNAP-ON LATCH
FOR STABILIZING BAR
NOTE: To avoid making a permanent hole, use the
Tie Rack
™
Stationary Belt Hooks
Fit the provided belt hooks into the four holes at the
bottom of the unit. Rotate 1/4 turn to secure. Each hook
will hold 2 belts.
Bulb Replacement
The light bulb has an extremely long life. In the unlikely
event that it fails, it can be replaced by a standard 6 volt
(4 cell) screw-based flashlight bulb. Remove the plastic
lens by unscrewing the adjacent two screws from the tie
rack. Slide the lens out.
Balancing Weight
Keep the ties balanced on the rack by spacing them
evenly apart. Don't fill only one side of the rotating belt
while leaving the other side empty.
ADAPTER CORD IN PLACE
LATCH RELEASE TABS
included mounting adhesive instead of a screw.
5
