The INTERMODO2 control board is a two-channel external receiver, which has an integrated decoding system. When a
channel is activated by radio control, the relevant N.O. relay contact closes by the methods described in chapter 5.
The selectable configurations are:
a Preperforated facility for cable grippers
a Preperforated facility for cable grippers
b Cover
b Cover
c Facility for securing on DIN guide
c Facility for securing on DIN guide
d Fittings for screw securing
d Fittings for screw securing
e Terminals for command output (N.O.)
e Terminals for command output (N.O.)
f Normally open (N.O.) relay contact
f Normally open (N.O.) relay contact
Signalling LEDs (ON= OUTPUT ACTIVE)
Signalling LEDs (ON= OUTPUT ACTIVE)
g
g
DL1=LED CH 1
DL1=LED CH 1
Radio programming push-buttons
Radio programming push-buttons
h
h
SW1=PUSH-BUTTON CH1
SW1=PUSH-BUTTON CH1
i DS1: Selection dip-switch
i DS1: Selection dip-switch
j Power supply terminal
j Power supply terminal
k Terminal for antenna
k Terminal for antenna
l DL3: Mains ON LED ( ON = MAINS PRESENT )
l DL3: Mains ON LED ( ON = MAINS PRESENT )
MODEL
POWER SUPPLY (V)
RECEPTION FREQUENCY (MHz)
ABSORBED CURRENT (A)
SAVEABLE CODES
NUMBER OF CHANNELS
NUMBER OF RELAY OUTPUTS (N.O.)
RELAY CONTACTS CAPACITY
PROTECTION CLASS
OPERATING AMBIENT TEMPERATURE (°C)
EXCLUSIVE USE
INTERMODO 868
1. DESCRIPTION
CH1= pulsed N.O. relay output
CH2= pulsed/fixed N.O relay output (selectable by DS1)
DL2=LED CH2
DL2=LED CH2
SW2=PUSH-BUTTON CH2
SW2=PUSH-BUTTON CH2
. TECHNICAL SPECIFICATIONS
This product complies with Directive 99/05/EEC
Product notified in all E.C. countries
4
DS1
DS1
ON
ON
OUTPUT
OUTPUT
DIP SWITCH 1
DIP SWITCH 1
CHANNEL 2
CHANNEL 2
FIXED
FIXED
NOT USED
NOT USED
DIP SWITCH 2
DIP SWITCH 2
INTERMODO2 868
12/24 ~
868.35±0.2
100 mA
250
2
N 1 pulsed (CH1)
N 1 pulsed/fixed (selectable) (CH2)
0.5 A / 120 VA
IP 44
-20 / +55
gate opener
OFF
OFF
OUTPUT
OUTPUT
CHANNEL 2
CHANNEL 2
PULSED
PULSED
NOT USED
NOT USED
Fig. 1
Fig. 1