Safety - Wolder AUTOBIKE PRO X3 Manual De Instrucciones

WOLDER AUTOBIKE PRO X3
-Holds 3 bikes (can hold 2, 4 bikes),
-accredited by the EC
-need not be submitted to Tuv testing
-just a few operations are required to assemble it on the vehicle and it's ready for use
-bicycles conveniently arranged in a low position
To all our esteemed customers:
It allows you to simply and conveniently transport 3 (or 2, max.4) bikes on your car. This bike carrier is
only supplied in the form of an assembly kit.
Before it can be used for the first time, the bicycle carrier must be assembled as described in these
directions for use.

1. Safety

Strictly comply with the following safety recommendations when assembling and using this bike carrier:
Note: carefully read all these instructions before beginning to assemble the bike carrier!
Comply with the safety recommendations in particular!
Warning: check the vehicle's tolerated axial load, it must not be exceeded when the bikes are
loaded! The tare weight of the bike carrier is 15 kg!
Warning: check the maximum bearing load tolerated by the tow bar attachment.
Maximum bearing load at least 75kg: in this case, 3 bikes weighing up to 52.5kg can be transported!
Maximum bearing load
transported!
Note: the vehicle must be equipped with a type-approved tow hook with a maximum bearing load of at
least 50 kg-must be at least type ST 52-3 or GGG 52.
90kg: in this case, 3 bikes (or 2,4 bicycles) weighing up to 67.5 kg can be