How To Fit The Bikes On The Bike Carrier - Wolder AUTOBIKE PRO X3 Manual De Instrucciones

7. How to assemble the bike carrier on the tow hook
Warning: before fitting the bike carrier on to the vehicle's tow hook, switch off the engine, turn the
ignition key to the off position and apply the hand brake!
The bike carrier is fitted on to the vehicle's tow hook in various different phases. This chapter describes
these phases in detail, in the succession required.
Phase 1
1) Place the bike carrier on the ground behind the vehicle.
2) Fit the power plug into the vehicle's socket.
Keep at due distance from the bike carrier /bike and the tail pipe of the car in order to avoid any
damages due to the excessive heat.
Phase 2
3) Now you have to open the quick stop system Fig.A.
4) Afterwards you can connect the rear towbar bike carrier to the towing hitch and you have to lift it
slightly Fig.B.

8. How to fit the bikes on the bike carrier

Warning: before fitting bikes on to the bike carrier, switch off the engine, turn the ignition key to the off
position and apply the hand brake! The vehicle must be in a horizontal position.
Bikes are fitted on to the bike carrier in different phases.
This chapter describes these phases in detail, in the succession required.
Phase 1
1) Open the tyre retainer belts, insert the first bike into the bike carrier from one side, with the handlebar
towards the left, then fix it on the U-bracket with the bearing arm.12
Phase 2
2) Insert the second bike in the opposite direction and fix it in place with the bearing arm Fig. F
Phase 3
3) Fix all the bikes again with the tyre retainer belt Fig.D