Wiring The Model Av1-Led; Single Power Supply For Light And Sounder; Figure 2 Mounting Hole Dimensions - Federal Signal AV1-LED Manual De Instalación Y Mantenimiento

0.75 in (19.1 mm)

Wiring the Model AV1-LED

The Model AV1-LED comes assembled from the factory with two color-
coded leads for wiring to a junction box. To connect the Model AV1-
LED directly to a power supply, simply remove the factory leads and
make the power connections to the terminal block located in the lower
housing.
SHOCK HAZARD—Do not connect the light to the system while
the power is on. Failure to heed this warning may cause serious
injury or death

Single Power Supply for Light and Sounder

Required for the installation are supply wires of the appropriate size
(12 AWG [3.0 mm2] maximum thickness).
To wire the light to a single power supply for the unit:
1. Turn off power to the system.
2. Remove and retain the three #8 screws securing the upper
housing to the lower housing. Remove the upper housing.
3. Remove the factory field-wiring leads from the terminal block.
4. Route supply wires of the appropriate gauge into the housing
through the conduit entry.

Figure 2 Mounting hole dimensions

3.50 in (88.9 mm)
Model AV1-LED Lights
Installation and Maintenance Manual
0.188 in (4.8 mm)
■
290A6505
9