Contents And Target Group Of The Instructions; General Safety Instructions; Meaning Of The Safety Instructions; Safety Instructions - hafele 633.52.330 Manual De Instrucciones

1. Contents and target
group of the
instructions
2. General safety
instructions
These operating instructions must be followed in order to operate the control unit
and the lifting device (e.g. electric table base or lift) correctly and safely.
The operating instructions must be read by the named groups of persons before
they handle the lifting device or the control unit.
Instruction part
1. Operating instructions Operators, qualified personnel (e.g.: joiners, cabinet

2.1 Meaning of the safety instructions

The safety instructions in these operating instructions are classified in accordance
with the severity of the danger.
WARNING
This safety instruction marks a potentially hazardous situation that could
lead to severe injuries.
NOTE
Notes are used to point out the possibility of consequential damage to the product
if they are not complied with. The note is also used to provide important additional
information.

2.2 Safety instructions

The following safety instructions must be observed during operation in
order to avoid hazards.
Safety instructions for operation
> The control unit must only be fitted by qualified personnel.
> Children may only use the control unit or the lifting device under the super-
vision of an adult.
> Do not attach any additional objects or support yourself on the lifting device.
> Immediately disconnect the lifting device from the power supply and contact
the manufacturer in the event of damage, smoke development or the occur-
rence of unusual noises/odours.
> Do not install any heat sources in the vicinity of the lifting device (candles,
heaters, etc.).
Electrical safety
> Do not allow liquids to flow into the control unit (e.g. by knocking over
containers filled with liquid on the worktop).
> Do not open the housing of the control unit.
> Do not interconnect any distributor boxes or adapters.
> Never replace or modify the mains plug / mains lead.

2.3 Correct purpose of use

The control unit is intended for the following use:
For vertical raising and lowering of a furniture item that is equipped with a lifting
device (worktop, sink, hob etc.).
applies to
makers, furniture manufacturers)
9