Safety Precautions - LG MultiVision AB-VL200X Manual Del Propietário

Safety Precautions

- If you are a professional installer, please read this manual carefully before installing the product.
- After installing the product according to the manual, ensure that the user also reads the manual carefully.
After reading the manual, please keep it handy for future reference.
The product should be installed by a qualified professional
specified by the retail store.
Installing the product without a qualified professional is dangerous and may
cause injury.
When moving or replacing the product after installation,
contact a qualified installer specified by the retail store.
Installation or movement of the product must be carried out by a skilled
professional. If an unqualified person moves and installs the product, this
may cause safety issues.
Prior to installing the product, arrange the power cable and
signal cable to prevent damage during installation.
Damaged cables may result in a fire, electric shock or damage to the product.
20cm
20cm
Follow the instructions in the manual to install the product.
If you do not follow the instructions, the product may not be installed properly,
causing serious injury or damage to the product.
Before installing the product, check whether the wall is strong enough to
hold the product.
Installing the product on a wall that cannot hold its weight may cause safety issues.
Do not clean the product with wet towels, and do not use a heater or
humidifier underneath the product.
Moisture permeating into the product, including through steam and heat, may
result in a fire, electric shock or damage to the product.
Make sure that the power cord is removed from the outlet before installing
the product.
Otherwise, it may cause an electric shock or a fire.
Warning
When sets are built in to a wall, the internal temperature may rise to such an extent that it
causes overheating, which may lead to a fire. To prevent the set from overheating, please
follow the instructions below.
Avoid completely sealed installation.
15cm
To ensure adequate ventilation, keep the top, the bottom and the sides of the set a
minimum of 20 cm from the wall. (The back of the set should be a minimum of 15 cm
from the wall.)
If there is not enough space, a separate ventilation device is required.
If you install four or more sets on top of one another, you will need to ensure a ventilator is
used. (for example, a forced draft fan.)
Caution
The product should be installed where its weight can be
supported.
If the product is installed on a weak surface, the product may fall and cause
injury.
Do not hang on the product or apply shock to the product.
The product may fall and cause injury.
To install or adjust the height of the product, two or more people are
needed.
If you try to install or move the product alone, it may fall and cause injury or damage to
the product.
Keep the product away from sprinklers, sprinkler sensors, high-tension
wires and power sources. Do not install the product in a location where
vibrations or shock impacts are likely to occur.
Wear working gloves when installing the product. Do not use bare hands.
Otherwise, it may cause injury.
3