MANUAL DE USUARIO
2.3.2. Assembly of the cell
Once the accessories have been glued, the cell can be assembled. Please follow the steps below:
1) The orientation of the cell housing must
always be vertical. Note that the tab marked
in the following picture is facing away from
the wall, i.e. towards you.
The control unit will be embedded on this
side, assuming you choose mounting type A
(cell and control unit in one block).
2) On the inside of the housing, you will notice
that there are two baffles marked IN and OUT.
These deflectors can be interchanged with
each other.
Choose the correct position according to your
hydraulic system, so that water enters the cell
through the deflector marked "IN" and exits
through the one marked "OUT".
Note:
The arrow in the picture above indicates the correct direction of
the water flow.
40