Brigmton BAI-300 Manual De Usuario página 21

3. Insert two AAA batteries into the earpiece battery compartment. Make
sure you match the correct polarity. Note the + and – icons on the
batteries and inside the battery compartments.
4. Slide the function switch (9) to the "DC2" position to switch to battery
mode.
5. Place the ear cushion onto the earpiece so that the locking noses of
the plastic frame are inserted into the corresponding notches on the
earpiece. Replace the ear cushion by pushing it carefully onto the
earpiece until it clicks into place.
To switch between conventional batteries and internal rechargeable
battery operation you must select the proper position with the function
switch (9).
Position "DC1" represents internal rechargeable battery operation
Position "DC2" represents conventional battery operation
The ear cushion is fixed on a plastic frame. You need to remove this
frame from the locking mechanism together with the ear cushion. Do not
pull on the ear cushion itself.
Pay attention to the proper setting of the function switch. If no batteries
are inserted and you have left the function switch at the "DC2" position,
the headphones will not power on.
Powering the Transmitter Cradle Using Batteries
The transmitter cradle battery compartment is located on the bottom.
1. Remove any cable connections and turn the transmitter cradle upside
down, holding it in your hand.