TECshow BUBBLE MASTER Manual De Usuario página 6

5. MAINTENANCE
Before doing maintenance, please make sure that
the power is cut, the power cord is unplugged.
The maintenance must be done by qualified per-
son.
1. For cleaning the interior of the machine and
the hole of bubble-blowing, unscrew the two
screws on each of the right side and the left side
of the back panel. Dismantle the module and
disconnect the 2-pin motor wires.
2. Clean the fan with cloth.
3. Clean the plastic cover with cloth.
4. After cleaning, put the module back by reverse
direction according to the instruction of point
1, and be sure that the motor wires are well
connected.
6. APPENDIX - A LC-3S
Wired Remote Control Operation:
The Bubble Master is designed with 3m wired
remote controller with JY cable. Once the bubble
machine is plugged, the red LED on this remote
controller will light up. When switch the button (B)
ON, the green LED lights up, and indicating the bub-
ble machine blows volumes of bubbles to the air.
Cable lengh: 3m
Connector: JY
Function: ON/OFF
Dimension (LxWxH): 90x50x24 mm
Weight: 0.28 kg
P. 6
Tecshow Bubble Master | English version
Important: When the bubble machine is not at
work, it is suggested to empty the bubble liquid
immediately and clean the tank with water. Please
note that the bubble liquid inside the bubble ma-
chine will get sticky after being exposed to the air
for a period of time, which will result failure of the
bubble blowing. Under such situation, please dilute
the bubble liquid with water to its proper concen-
trarion for use. Bubble blowing will be revitalized
then.
A. JY cable
B. Button
C. Green LED (blow)
D. Red LED (power)