Tabla de contenido
Idiomas disponibles
Idiomas disponibles
GB
KS
2.6
Spare parts service
Visit
our
website
tems.com/td/ for the latest version of all ex-
ploded drawings and spare parts lists for our
products. If you have any special questions,
please consult the Schneider Airsystems Ser-
vice centre in your country (addresses in the
service appendix) or your local dealer.
2.7
Warranty conditions
Basis for warranty claims: complete unit
in original condition/proof of purchase.
2.8
Troubleshooting
Observe the safety instructions and maintenance instructions!
Problem
A
Car body saw does
not cut correctly
B
Minimum or no
operating capacity
*For troubleshooting: refer to the information in the "Technical data" chapter in part 1 of the instruction manual!
****For troubleshooting: read chapter: "Maintenance"!
If necessary, contact our service staff, see last page.
II/ 8
www.schneider-airsys-
Cause
Saw blade (item 04) dirty,
damaged or blunt
Saw blade blunt
Tool worn
Working pressure (flow pres-
sure) too low
Compressor output too small
Hose diameter too small
Hose line too long
Poor / No lubrication
According to legal provisions, you re-
ceive the following warranty against
material and manufacturing defects:
private use only: 2 years,
commercial use: 1 year.
Excluded from warranty claims: Wear or
expendable parts, improper use, overloading
/ incorrect pressure, manipulation / inappro-
priate use, inadequate / incorrect / lack of
maintenance or lubrication, bumps / im-
pacts, dust / dirt accumulation, unauthorised
/ incorrect working procedures, incorrect
power supply, impure / insufficiently filtered
compressed air, failure to read the instruc-
tion manual, incorrect operating resources /
materials.
Remedy
Clean the saw blade or replace
Replace the saw blade
Replace tool
Increase working pressure (flow
pressure)
working pressure
Use different output
*
rating
Use correct hose diameter
Use correct hose
diameter
Arrange appropriate lubrication
Observe
maximum
*
*
*
****
Capítulos
Tabla de contenido
Solución de problemas
