Fcc Rules; Industry Canada - Gear4 HouseParty Portable Wireless Manual Del Usuario

FCC RULES

You are cautioned that changes or modifications
not expressly approved by the party responsible
for compliance could void the user's authority to
operate the equipment. This equipment has been
tested and found to comply with the limits for a
Class B digital device, and a Class C Low Power
Transmitter, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates, uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
‒ Reorient or relocate the receiving antenna.
‒ Increase the separation between the
equipment and receiver.
‒ Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
‒ Consult the dealer or an experienced radio/
TV technician for help.
6 GEAR4 / HouseParty Portable Wireless / User Manual
PG731EUK_HouseParty_Portable_Wireless_Manual_V1.0.indd 6
Operation is subject to the following two
conditions:
1) This device may not cause interference and
2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
The antennas used for this transmitter as shown in
this filing must be installed to provide a separation
distance of at least 20 cm from all persons and
must not be co-located or operating in conjunction
with any other antenna or transmitter.

INDUSTRY CANADA

This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions:
1) this device may not cause interference, and
2) this device must accept any interference,
including interference that may cause
undesired operation of the device.
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna
of a type and maximum (or lesser) gain
approved for the transmitter by Industry Canada.
To reduce potential radio interference to other
users, the antenna type and its gain should
be so chosen that the equivalent isotropically
radiated power (e.i.r.p.) is not more than that
necessary for successful communication.
This Class B digital apparatus complies with
Canadian ICES-003.
17/08/2012 14:35