Tabla de contenido
DISPLAY
by pressing the Enter-button.
When you turn on the laser for the first time, it will take some seconds to auto load the built-in show. The
default setting is AUTO EFFECT 1.
First Menu
DMX512
AUTO
(Auto running mode)
Music
(Sound activate mode)
Testing
Setting
Default
ONE BEAM PROTECTION
For safety reason you can switch the One Beam protection On/Off via display. If the One Beam is activated (ON) highly
focused single beam are suppressed. Switch to OFF to deactivate the One Beam protection.
This function should only be turned off by well-trained operator, after checking well all safety aspects!
All manuals and user guides at all-guides.com
The control board offer several features: you can simple set the starting address,
run the pre-programmed program or make a reset. The main menu is accessed
by pressing the Mode-button, browse through the submenu by pressing Up or
Down.
Press the Enter-button in order to select the desired menu.
You can change the selection by pressing Up or Down. Confirm every selection
Second Menu
Third Menu
Running
A001 (DMX address)
Show 001~010
Show 001~010
Scan 30KPPS
Scan
(Press "UP" and "DOWN" to choose different speed)
1. Single (1~7)
2. RGY
3. RBP
Color
4. GBA
5. RGB
6. WYAP
Light
ON (Always ON)
(LCD backlight setting)
ON 5S (ON for 5 seconds)
OFF
One Beam
ON
OFF
Master (set master unit)
ON
13CH
Channel
25CH
TTL Mode
Colour (only valid for multi colour laser)
Yes
No
12
Tabla de contenido
