Pelonis FS45-3ER Manual Del Propietário página 4

Fig.5
OPERATING INSTRUCTIONS
I. Remote Controller (Fig.8)
" " ON/OFF KEY
The key is for switching on the fan. The fan will be started at low
speed. Press the key again, it will be switched off.
" " TIMER KEY
When this key is touched repeatedly, the time to be set 1,
2 and 4 hours and the correspond pilot lamp will light. If the
lamp don't light after you touched the key, the fan will run
continuously.
" " SPEED KEY
After the fan has started, this key serves as a speed selector in the sequence from
"low-medium-high-low" when this key being touched repeated or continuously.
" " MODE KEY
Press this key to select mode. This key is a selector key for wind type. The wind
type changes in the sequence from NORMAL---NATURAL---NORMAL wind when
this key being touched repeatedly or kept in.
II. Control Panel (Fig.9)
Press the lower center button to Start and Stop fan and to
select Low, Medium or High fan speed. Press the middle center
button to select 1, 2 or 4 hour automatic shutoff time period
of operation.
NOTE: There is no Mode key on the control panel. Mode
function must be activated from the remote control.
III. Oscillation Control
To make the fan oscillate, press the clutch knob located on the
top of the motor housing. To get the directional airflow, pull the
clutch knob up to its initial position.
IV. Tilt Adjustment
To adjust the air flow upward or downward, push the grilles
lightly to the desired direction.
Fig.6
3
Clip
Fig.7
Fig.8
Fig.9