Pelonis FS45-3ER Manual Del Propietário página 3

ASSEMBLY OF CHASSIS & COLUMN UNIT
1. Unscrew the bent anchor bolt from the Extension Pole. (Fig.1)
2. Insert the extension pole into the chassis and tighten the bent anchor bolt (Fig.2)
3. From the extension pole, loosen the height adjustment ring and adjust the internal
pole to the desired height. (Note: If you can't find the internal pole, might have fallen
inside the extension pole. You can pull it out from the extension pole.) (Fig.3)
4. To attach the head unit to the internal pole, loosen the thumb screw on the bottom
of the head unit. Place the head unit on the internal pole and tighten the thumb
screw in alignment with the groove on the internal pole. (Fig.4)
CAUTION: Height adjustment ring must be fully fastened before the assembly of the
motor section to the internal pole.
Fig.1
Fig.3
GRILLE & FAN BLADE ASSEMBLY
1. Unscrew the spinner clockwise to remove it from the motor shaft. Unscrew the
plastic nut counterclockwise to remove it from the motor housing. Secure the rear
grille to the motor housing with the plastic nut. (Fig. 5)
2. Insert the blade into shaft, and make sure the rotor shaft pin is fitted into groove
on the blade. Turn the spinner counterclockwise to secure the blade. (Fig. 6)
3. Fasten the front grille and the rear grille by the grille clips. (Fig. 7)
Fig.2
Fig.4
Loose e n
2
Mounting hole
Thumb screw
Annular groove