Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5
Use combination carpet & floor brush for vacuuming
both hard surfaces and carpets. To clean hard surfaces
– wooden floors, plastic floors, ceramic tiles etc. pull out
the brush by pressing the switch on the combination
brush according to the figure
when vacuuming carpets (set the switch in "
6
The vacuum cleaner is equipped with an accessory
compartment. To open the compartment, lift the
compartment lid and pull it downwards.
7
Grab the plug (3) and pull the cord out of the
vacuum cleaner.
While pulling out the cord pay attention
to the yellow stripe which signals the
end of the cord. Further attempts (pulling
on cord) may result in damaging the cord.
8
Plug in the appliance.
Before operation make sure that the SAFBAG dust bag
module is installed in the vacuum cleaner chamber and
that all filters are installed in the appliance.
9
Switch on the vacuum cleaner by pressing the "on/
off" button (7).
10
The vacuum cleaner is equipped with an electronic
power control which allows to gradually adjust the
vacuum cleaner suction power during operation.
To adjust the suction power use the power adjustment
buttons (11,9)
– to increase the suction power or
– to decrease the suction power. The suction power
setting is indicated by the appropriate number of lit
diodes.
The vacuum cleaner will by default begin operation
at the medium power range. 4 diodes will light on the
power level indicator (10).
The suction power may be adjusted during operation.
The recommended settings are:
Setting 1 – vacuuming curtains
Setting 2 – vacuuming upholstery
Setting 3 – vacuuming carpets
Setting 4 – vacuuming hard floors and crevices
Setting 5 – maximum suction power.
The power may also be adjusted individually depending
on the type of surface, vacuum effectiveness and
suction power of the switchable combination brush.
11
Set the desired power value by pressing the power
adjustment buttons
,
. Retract the brush
").
(11,9).
SAFBAG dust bag disassembly/
assembly
Vacuum cleaner is equipped with SAFBAG bag (1 piece).
1
The vacuum cleaner is equipped with a dust bag
full indicator (8). When the dust bag full indicator (8)
lights during operation (with the nozzle or the brush
lifted above the cleaned surface) it means that the bag
is full and needs to be replaced. In addition the dust
bag full indicator (8) may activate if the suction hose or
the elements attached to the suction hose are clogged.
2
Switch off the vacuum cleaner by pressing the "on/
off" button (7) and unplug the appliance.
3
Press the two side buttons on the end of the hose
and remove the hose end from the inlet opening of the
vacuum cleaner.
4
Release the upper cover fastening (12) and open
the cover.
5
Remove the SAFBAG dust bag module (18) from
the vacuum cleaner chamber.
6
Grab the dust bag cover, gently bend it towards the
inside and remove the whole dust bag upwards.
7
Insert the plate of the new dust bag in the tracks
of the SAFBAG dust bag module (18) and slide it until
stop.
8
Slide the SAFBAG dust bag module together with
the installed bag in the tracks located on the side of the
vacuum cleaner chamber. Close the cover by pressing
it until you hear a characteristic click – pay attention
not to trap the dust bag.
Do not vacuum without the SAFBAG
dust bag module installed in the
appliance. The lack of the SAFBAG dust
bag module prevents from locking the upper
cover of the appliance.
It is recommended to replace the dust bag if:
a) the dust bag full indicator lights up,
b) the vacuum cleaner operates poorly,
c) the dust bag is full.
Filter disassembly
Before changing the filters make sure that the vacuum
cleaner is switched off and unplugged from the mains
supply.
C
Tabla de contenido
