Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
-Before finally installing the unit, connect the wiring temporarily and make sure it is all connected up properly and the unit
and system work properly.
-Use only the parts included with the unit to ensure proper installation. The use of unauthorized parts can cause
-Consult with your nearest dealer if installation requires the drilling of holes or other modifications of the vehicle.
-Install the unit where it does not get in the driver's way and cannot injure the passenger if there is a sudden stop, like an
emergency stop.
-Avoid installing the unit where it would be subject to high temperature, such as from direct sunlight, or from hot air, from
heater, or where it would be subject to dust dirt or excessive vibration.
DIN FRONT/REAR-MOUNT
This unit can be property installed either from Front (conventional DIN Front-mount) or Rear (DIN Rear-mount installation,
utilizing threaded screw holes at the sides of the unit chassis).
For details, refer to the following illustrated installation methods A and B.
- DIN FRONT-MOUNT (Method A)
Installation the unit
1
2
182
53
Removing the unit
a
b
c
1. Dashboard
2. Holder
After inserting the half sleeve
into the dashboard, select the
appropriate tab according to the
thickness of the dashboard
material and bend them inwards
to secure the holder in place.
a. Frame
b. Insert fingers into the groove
in the front of frame and pull out
to remove the frame. (When re-
attaching the frame, point the
side with a groove down wards
and attach it.)
c. Insert the levers supplied with
the unit into the grooves at both
sides of the unit as shown in
figure until they click. Pulling the
levers makes it possible to
remove the unit from the
dashboard.
E - 1
- DIN REAR-MOUNT (METHOD B)
Installation using the screw holes on the sides of the unit.
Fastening the unit to the factory radio mounting bracket.
3
2
5
1. Select a position where the screw holes of the bracket
and the screw holes of the main unit become aligned (are
fitted) and tighten the screws at 2 places on each side.
2. Screw
3. Factory radio mounting bracket.
4. Dashboard or Console
5. Hook (Remove this part)
Note: the mounting box, outer trim ring, and half-sleeve
are not used for method B installation.
malfunctions.
2
4
5
Tabla de contenido
