TecMate Optimate lithium TM470 Modo De Empleo página 7

NOTES ON TEST RESULTS:
1. For any test result other than green #5, disconnect the battery from the electrical system it supports, and reconnect the OptiMate. If a
better test result is now obtained, this suggests that the power losses are partly due to an electrical problem in the electrical system and not
in the battery itself. If the poor result persists, you are advised to take the battery to a professional service workshop equipped with
professional equipment for a more thorough investigation.
2. If the red LED #6 alone, or the GREEN #5 and red LED #6 indicate together, a significant problem exists. The green + red LEDs mean that
after being charged the battery's voltage is not being sustained or that despite recovery attempts the battery was irrecoverable. This may be
due to a defect in the battery itself, such as a short-circuited cell or total sulphation, or, in the case of a battery still connected to the
electrical system it supports, the red LED #6 may be signalling a loss of current through deteriorated wiring or a degraded switch or contact,
or in-circuit current-consuming accessories. A sudden load being switched on while the charger is connected can also cause the battery
voltage to dip significantly.
3. GOOD TEST RESULT, but the battery cannot deliver sufficient power: Permanent damage within the battery may be causing excessive
self discharge that is not detected within the test period of 12 hours. Disconnect the battery from the OptiMate.
AUTOMATIC BATTERY MAINTENANCE:
The MAINTENANCE CHARGE CYCLE consists of 30 minute charge periods followed by
and alternating with a 30 minute 'rest' periods, during which there is no charge current. The circuit offers current to the battery within a safe
13.6V voltage limit ("float charge"), allowing it to draw whatever small current is necessary to sustain it at full charge and compensate for
any small electrical loads imposed by connected circuitry, or the natural gradual self-discharge of the battery itself.
The BATTERY REFRESH CYCLE is performed if the charger detects the battery has lost charge. The program returns to OPTIMIZE mode (LED
#4) and then proceeds to the voltage retention test and maintenance charge cycle.
LIMITED WARRANTY
TecMate (International) SA, Sint-Truidensesteenweg 252, B-3300 Tienen, Belgium, makes this limited warranty to the original purchaser at
retail of this product. This limited warranty is not transferable. TecMate (International) warrants this battery charger for three years from date
of purchase at retail against defective material or workmanship. If such should occur the unit will be repaired or replaced at the option of the
manufacturer. It is the obligation of the purchaser to forward the unit together with proof of purchase (see NOTE), transportation or mailing
costs prepaid, to the manufacturer or its authorized representative. This limited warranty is void if the product is misused, subjected to
careless handling, or repaired by anyone other than the factory or its authorized representative. The manufacturer makes no warranty other
than this limited warranty and expressly excludes any implied warranty including any warranty for consequential damages.
THIS IS THE ONLY EXPRESS LIMITED WARRANTY AND THE MANUFACTURER NEITHER ASSUMES NOR AUTHORIZES ANYONE TO ASSUME OR
MAKE ANY OTHER OBLIGATION TOWARDS THE PRODUCT OTHER THAN THIS EXPRESS LIMITED WARRANTY. YOUR STATUTORY RIGHTS ARE
NOT AFFECTED.
NOTE: Details at www.tecmate.com/warranty.
copyright © 2014 TecMate International
OptiMate, OptiMate Lithium and the names of other battery care products mentioned in these instructions such as BatteryMate,
TestMate and TestMate mini, are registered trademarks of TecMate International NV.
WARRANTY in Canada, USA, Central America & South America:
TecMate North America, Oakville, ON, Canada, as a wholy owned subsidiary of TecMate International, assumes the responsibility for product
warranty in these regions.
More information on TecMate products can be found at www.tecmate.com.
7