Preparing For Use; Use; Electrically Adjustable Sections; Malfunctions - Auping Kiruna Manual De Instrucciones

3.3 Preparing for use

Attach the legs to the boxspring.
Always place a (fifth) central leg in
case of flat boxsprings longer than
200 cm.
fig. 10
Position the boxspring correctly on
the supporting legs. Check that the
boxspring can move freely.
Place the mattress(es) on the box-
spring.
Insert the plug into the mains socket*.
*If applicable
GB 8
All manuals and user guides at all-guides.com

4. Use

4.1 Electrically adjustable sections

The handset is used to adjust the
electrically adjustable sections (see
fig. 11).
P ress one of the 'up' or 'down'
buttons, holding it down until the
desired position is reached. Only one
button can be operated at a time.
1. Raise back section
2. Lower back section
3. Raise foot end
4. Lower foot end
5. Raise back section and foot end
6. Lower back section and foot end
fig. 11

5. Malfunctions

While an electrical fault may be a
nuisance, it is not dangerous. The
motor is fitted with all necessary
safety provisions and has double
insulation.

5.1 Electrical malfunctions

Check that:
- the plug is in the socket;
- the current is switched on at the
mains;
- the battery of the infrared handset is
charged;
- the infrared receiver is not ob-
structed;
- the frequency of the infrare d
receiver is the same as that of the
infrared receiver. The handset and
the receiver are fitted with a
frequency switch.
The infrared handset cannot be used
simultaneously with other infrare d
remote controls.
The infrared receiver is fitted with an
e m e rg ency button. When this is
pressed all adjustable parts return to
the horizontal position.
Battery
The infrared handset requires a 9 Volt
block battery.
To insert the battery:
- remove the lid at the back of the
handset and insert the battery;
- the remote control offers space for
a spare battery.
Batteries are chemical waste.
Dispose of batteries according to the
local regulations for household
chemical waste.
Please note! When replacing the
battery, use of the type 6LR61-9V is
recommended.

5.2 Mechanical malfunctions

Undesirable noises (bed squeaks
and creaks)
Unwanted noises are usually caused
by:
- the bed not being properly hori-
zontal;
- the legs are not properly tightened;
- the bed is not positioned away from
the wall.
GB 9