dirna Bergstrom SLIM COOL EURO 5 Serie Diagnosis De Averías página 21

SLIM COOL
• Repair the possible obstruction of the blower or the condenser fan; if the error
persists, replace the blower or the condenser fan (remove the outside cover of the
unit in order to access the blower or the condenser fan; for the blower, also remove
the evaporator cover).
• Replace the 7.5A fuse. To access the condenser fan or blower fuses, it is necessary
to take down the control panel access cover in the interior air distribution panel.
!
(If the error persists, contact the Authorised Technical Service).
• Reprogramme the remote control.
• Replace the remote control's battery and reprogramme.
• Replace the electronic control. To access the electronic control, it is necessary to
take down the control panel access cover in the interior air distribution panel.
• Replace the remote control.
!
(If the error persists, contact the Authorised Technical Service).
• Correctly connect the terminals of the compressor's electronic module. (See attached
wiring diagram).
• Replace the compressor electronic module(s).
• Replace the compressor(s).
• Check the pressure (the compressors disconnect after 6 bars); if necessary, recover
gas and load 250 g again per circuit. To access the compressors, modules or load
points it is necessary to take down the unit's outside cover.
!
(1) Each time it is necessary to extract or introduce gas charge out of/in circuit, it is necessary to
(If the error persists, contact the Authorised Technical Service).
do it using adequate machinery and always respecting the environment. The refrigerant gas
recovery will never be accurate because part of this gas will remain inside the presure gauge
pipes.
• Take down the control panel access cover in the interior air distribution panel,
correctly connect the connection cable between the control panel and the electronic
control.
Solution
21
EN
®