SUNTEC SPI-8380 Instrucciones De Uso página 10

Operation
•
Operating voltage: 220-240V~, 50/60 Hz, 100W
•
Please remove all packaging material and clean the pusher, filler pipe, blade holder, all blades and the
container prior to first use. Please follow the instructions from the segment "Cleaning".
•
Please make sure that the appliance is turned off at the on-/off-button. The appliance should be
disconnected from the power outlet before assembling the spiral cutter.
•
Choose a blade of your liking and insert it into the blade holder (see picture 1). While doing so, only
touch the plastic part, never the blade itself. Blade and blade holder should form a cone together after
locking them in place.
•
Place the blade holder into the appliance at the motor base (see picture 2) and turn the blade holder
anti-clockwise until the stop ("CLOSE"). The blade holder is positions correctly when the blade holder
cannot be pulled up anymore.
•
To attach the filler pipe to the appliance, put the filler pipe on top of the blade holder with the pipe side
upwards. Turn the filler pipe clockwise until the stop.
•
After assembling you can connect the appliance to the power outlet.
•
Solid and long vegetables, e.g. carrots and zucchinis, with a diameter between 3 and 6 cm are most
suitable for the spiral cutter. Please cut one end and insert the cut end into the filler pipe. You can fix the
vegetable with the pusher to avoid turning during the cutting process.
•
Please press the on-/off-button and press the pusher downwards with equal pressure until the vegetable
is cut completely (see picture 3). If you wish to have shorter noodles, take breaks of about 5 seconds
when you press down the pusher. During these breaks without any pressure, the vegetable will not touch
the blades and the noodles will be cut. The appliance should be turned off after an operation of 2 minutes
to avoid overheating of the motor. The appliance can be used again when it has cooled down.
•
To turn the appliance off, press the on-/off-buttom. If you wish to change the blades, remove the
appliance from the power outlet. Please turn the filler pipe anti-clockwise and pull it up. Next, turn the
blade holder clockwise and remove it. Please press on the marked spots of the blade holder, as seen
in picture 4, and push the blade upwards while pressing.