Emptying Dirt Tank; Replacing Filter Element - MIRKA 412 Manual De Instrucciones

Mirka 412 / 415 / 415 M
english

7.2.3 Emptying dirt tank

Only after picking up harmless dust
without a filter bag.

7.2.4 Replacing filter element

Mirka 415 M: During the following
work, ensure that dust is not unnec-
essarily spread around. Wear a P2
breathing mask.
5
10
1 3
2
6
1. Remove the upper section of
2. Using one hand, take hold of
3. Dispose of the dirt in accord-
4. Clean the rim of the tank be-
Before reinserting the suction
hose:
5. Clean the inlet fitting and hose
1. Open the retaining clamps
2. Turn the filter holder anti-
3. Mirka 415 M: Place the pro-
4. Carefully remove the filter el-
5. Clean the filter seal (4).
6. Check the antistatic clamp
4
7. Fit a new filter element.
8. Check that the float (6) works
1
9. Fit the filter holder and turn it
2
10.Dispose of the used filter ele-
Never use the vacuum cleaner
without a filter.
cleaner from the dirt tank.
the dirt tank underneath and
tip out the dirt.
ance with legal regulations.
fore fitting the upper section
of cleaner.
collar.
and remove the upper sec-
tion of the cleaner from the
dirt tank. Lay the upper sec-
tion of the cleaner down with
the filter element facing up-
wards.
clockwise (1) and remove it
(2).
tective filter bag over the filter
element (3).
ement and close the protec-
tive filter bag with a knot.
Check it for damage and re-
place it if necessary.
(5) for damage and have it
replaced by the Service if
necessary.
properly. When the filter hold-
er is turned, the float inside
must move about easily.
clockwise to secure it firmly.
ment in accordance with le-
gal regulations.