Idiomas disponibles
Idiomas disponibles
LIFT CORPORATION Sht. 4 of 42 DSG#
Keep dirt, water and other contaminants from entering the hydraulic system.
Before opening the hydraulic fluid reservoir filler cap, drain plug and hydrau-
lic lines, clean up contaminants that can get in the openings. Also, protect the
openings from accidental contamination.
4. Disconnect high pressure line and fittings
from pump assembly (FIG. 4-1). Do not
discard flow valve, as it will be reused
during installation.
5. Measure, mark, and drill holes in
mounting plate for the mounting
bracket (FIG. 4-2).
6. Measure, mark, and drill 2 holes for
spring clips (FIG. 4-3).
© MAXON Lift Corp. 2017
CAUTION
DISCONNECTING HIGH PRESSURE LINE
HOLE PATTERNS FOR MOUNTING BRACKET
1-1/2"
HOLE DIA.
.196" MAX
.192" MIN
(2 PLACES)
HOLE PATTERNS FOR SPRING CLIPS
M-13-07
Rev. - Date: 07/12/17
FIG. 4-1
HOLE DIA. 3/8"
(2 PLACES)
15/16"
9-1/4"
FIG. 4-2
6"
9-3/16"
1-1/2"
FIG. 4-3
2-3/8"
