GMC GER1800 Manual Del Usuario página 12

Base Plate
• The router features a combined flat-sided and round Base Plate (14). This allows the
round edge to follow contours easily but also gives an easy straight edge which may be
useful for some straight cuts (when the Parallel Guide (30) cannot be used), using with
guide bushes and also where the edge of the Base Plate needs to be closer to the router
bit cutter, e.g. for use with dovetail jigs etc.
• Always remember which edge of the base plate you are working with as the distance is
different to the router bit cutter
• If the router bit cutter impacts hard material such as metal the router bit will be destroyed
and the router itself may be damaged
Accessories
GB
• A wide range of accessories for this tool, including a large selection of router bits and other
accessories is available from your GMC stockist. Spare parts, including carbon brushes,
guide bushes and collets are available from your GMC stockist or
www.toolsparesonline.com
Maintenance
WARNING: ALWAYS disconnect from the power supply before carrying out any
inspection, maintenance or cleaning.
General inspection
• Regularly check that all the fixing screws are tight
• Inspect the supply cord of the tool, prior to each use, for damage or wear. Repairs should
be carried out by an authorised GMC service centre. This advice also applies to extension
cords used with this tool
Cleaning
• Keep your tool clean at all times. Dirt and dust will cause internal parts to wear quickly, and
shorten the machine's service life. Clean the body of your machine with a soft brush, or dry
cloth. If available, use clean, dry, compressed air to blow through the ventilation holes
• Clean the tool casing with a soft damp cloth using a mild detergent. Do not use alcohol,
petrol or strong cleaning agents
• Never use caustic agents to clean plastic parts
Lubrication
• All the bearings in this tool are lubricated with a sufficient amount of high-grade lubricant
for the life of the unit under normal conditions. Therefore, no further lubrication is required.
Brushes
• Over time the carbon brushes inside the motor may become worn
• Excessively worn brushes may cause loss of power, intermittent failure, or visible sparking
• To replace the brushes;
1. Face the router down horizontally with the flat edge of the Base Plate (14) at the bottom
2. Remove the Brush Access Screws (21) from the motor cover
3. Gently slide the motor cover off horizontally so the Speed Adjustment Buttons (3) remain
in place and do not fall out
4. Lift the edge of the Carbon Brush Holders up and carefully pull out (Image M) so the notch
at the bottom is clear
5. Disconnect the spade terminal and replace the carbon brushes on both sides
6. Refit into brush housing on both sides, refit motor cover and Brush Access Screws
ensuring the Speed Adjustment Buttons stay in place
• Alternatively, have the machine serviced at an authorised service centre
Note: Always replace carbon brushes in pairs and once fitted the brushes may take a short
time to bed in.
Storage
• Store this tool in a secure, dry location out of the reach of children
Disposal
Always adhere to national regulations when disposing of power tools that are no longer
functional and are not viable for repair.
• Do not dispose of power tools, or other waste electrical and electronic equipment (WEEE),
with household waste
• Contact your local waste disposal authority for information on the correct way to dispose
of power tools
12