2
Attach Side Mounting Rails
Attach both left and right side rails to the truck
bed. The end of the mounting rail with the
drain tube tting will go towards the cab of the
truck.
Position the top edge of the mounting rail ush
to the top edge of your truck bed rail, Figure 1 &
2. Using three (3) clamps per side attach the rail
to the bed, position the clamps adjacent to each
of the black rail spacers. (Tip: Mount the center
clamp rst but do not tighten completely. This
will give you the ability to adjust the rail as the
outer clamps are attached) Tighten the clamps
using a 1/2" wrench or socket, Photo A.
Note: If you discover your truck will not allow you
to position a clamp adjacent to the spacer, simply
slide the spacer forward or back as needed.
Install the Bulkhead Seal to the front rail of the
truck bed and cut to length.
Warning! Do not overtighten the
clamp assembly. A torque wrench
is not necessary. If preferred,
torque is apx 75 inch lbs.
Warning! Clamps must be
checked periodically for tightness.
Failure to do so could result in
damage to you or your property.
UnderCover, Inc.
P.O. Box 620
Rogersville, MO 65742
(417) 753-8000
(866) 900-8800
MODEL SPECIFIC GUIDE
Multiple Applications Ford, Mazda, Dodge, Mitsubishi, Isuzu & Volkswagen
Truck Bed Rail
Truck Speci c
Clamp Assembly
www.undercoverinfo.com
Cover Mounting Rail
Rail Spacer
© 2016 UnderCover, Inc.
All rights reserved.
