Operation - Husky H4455 Manual Del Usuario

Operation

1
Operating the impact wrench
□ This 1/2 in . Impact Wrench is designed to operate on
90 PSIG . Lower pressure (below 90 PSIG) will reduce
performance of the tool . Higher air pressure (over 90
PSIG) raises the performance of the tool beyond its rated
capacity and could cause serious damage to the tool and
the user .
3
Changing the output torque level
□ This tool features the air regulator to manage the output
power located on the back of the housing .
□ Turn the knob to adjust to your desired torque level .
□ The left setting is the lowest power level, the center setting
is a medium power level, adn the right setting is the
highest power level .
2
□ This tool features the reverse switch to change the
□ Control the output torque direction by turning the reverse
4
To install the impact socket:
□ Disconnect the tool from the air source .
□ Select the suitable and desirable socket size .
Forward
□ Press fit the anvil into the socket .
□ To remove the impact socket:
□ Disconnect the tool from the air source .
□ Use your hand or a suitable tool to remove the socket .
6
Changing the output torque direction
output torque direction to tighten (assemble) or loosen
(disassemble) the bolt or fastener .
switch button to the Forward arrow or Reverse arrow
position to change the direction .
Installing and removing the impact
sockets
WARNING: Disconnect the tool from the air supply before
servicing or changing accessories . Always use sockets rated
for impact wrenches .