Broan Best IS241 Manual De Instrucciones página 9

OPERATION
Controls
The hood is operated using the (5) push-but-
tons located at eye-level, on the front edge of
the hood.
The light switch turns the halogen lights on
and off.
The blower on-off / speed 1 switch turns the
blower on to its lowest running speed. Turn the
blower off by pressing this switch a second time.
The blower speed 2 switch turns the blower on to medium-low running speed.
Pressing this switch a second time sets a timer which keeps the blower operating at
this speed for 10 minutes.
The LED will blink during this time and the blower will shut off automatically.
The blower speed 3 and blower speed 4 switches operate the same as blower
speed 2 switch except: Blower speed 3 is medium-high and blower speed 4 is high.
At the end of each working time of 30 hours, all the leds blink at the same time; this
indicates that the grease filter need to be cleaned.
Once the clean grease filter are on, push one of the three speed switches to make
the count down start again.
HALOGEN BULBS
This range hood requires two halogen bulbs
(Type MR16, 12V, 20W).
ALWAYS SWITCH OFF THE ELECTRICITY
SUPPLY BEFORE CARRYING OUT ANY
OPERATIONS ON THE APPLIANCE.
To change bulbs:
1. Remove the grease filter.
2. Remove bulbs by pulling them straight downward. Do not rotate bulbs.
3. Replace bulbs by aligning the bulb's pins with the receptacle holes and pushing
bulb upward.
IN CASE THE NEW HALOGEN BULB DOES NOT LIGHT UP ONCE IT IS ON,
CALL THE QUALIFIED PERSON.
LIGHT
SWITCH
BLOWER
ON-OFF /
SPEED 1
0-1
- 9 -
BLOWER
SPEED 2
BLOWER
SPEED 3
BLOWER
SPEED 4
LED LED LED
2 3 4
LED