Limited Warranty; Troubleshooting Guide - Zoeller 314 Instrucciones De Instalación

Manufacturer warrants, to the purchaser and subsequent owner during
thewarrantyperiod, everynewproduct tobefreefromdefectsinmaterial
and workmanship under normal use and service, when properly used
and maintained, for a period of one year from date of purchase by the
end user, or 18 months fromdate of original manufacture of the product,
whichever comes¿ rst. Partsthat fail withinthewarrantyperiod, oneyear
from date of purchase by the end user, or 18 months from the date of
originalmanufactureoftheproduct,whichevercomes¿ rst,thatinspections
determine to be defective in material or workmanship, will be repaired,
replacedor remanufacturedat Manufacturer'soption, providedhowever,
that by so doing we will not be obligated to replace an entire assembly,
the entire mechanismor the complete unit. No allowance will be made
for shipping charges, damages, labor or other charges that may occur
due to product failure, repair or replacement.
This warranty does not apply to and there shall be no warranty for any
material or product that has been disassembled without prior approval
of Manufacturer, subjectedtomisuse, misapplication, neglect, alteration,
accident or act of nature; that has not been installed, operated or main-
tained in accordance with Manufacturer's installation instructions; that
has been exposed to outside substances including but not limited to the
following: sand, gravel, cement, mud, tar, hydrocarbons, hydrocarbon
derivatives (oil, gasoline, solvents, etc.), or other abrasive or corrosive
substances, wash towels or feminine sanitary products, etc. in all pump-
ELECTRICAL PRECAUTIONS- Before servicing a pump, always shut off the main power breaker and then unplug the
pump. Make sure you are not standing in water and are wearing insulated protective sole shoes. Under À ooded conditions, contact your
local electric company or a quali¿ ed licensed electrician for disconnecting electrical service prior to pump removal.
A. Pump will not begin 1. Air leak in inlet line
pumping or retain prime
after operating, or stops 2. Fittings not tight
pumping water 3. Hose kinked or looped
4. Inlet hose out of water
5. Clogged inlet
6. Inlet lift too high
7. Impeller blocked
8. Worn seal
B. Pump will not start or 1. Blown fuse
run 2. Lowline voltage
LIMITEDW ARRANTY
ing applications. The warranty set out in the paragraph above is in lieu
of all other warranties expressed or implied; and we do not authorize
any representative or other person to assume for us any other liability in
connection with our products.
Contact Manufacturer at, 3649 Cane Run Road, Louisville, Kentucky
40211, Attention: Customer Support Department to obtain any needed
repair or replacement of part(s) or additional information pertaining to
our warranty.
MANUFACTURER EXPRESSLY DISCLAIMS LIABILITY FOR SPE-
CIAL, CONSEQUENTIAL OR INCIDENTAL DAMAGES OR BREACH
OF EXPRESSED OR IMPLIED W ARRANTY; AND ANY IMPLIED
W ARRANTY OF FITNESS FORA PARTICULAR PURPOSE AND OF
MERCHANTABILITYSHALLBELIMITEDTOTHEDURATIONOFTHE
EXPRESSEDW ARRANTY .
Some states do not allow limitations on the duration of an implied war-
ranty, so the above limitation may not apply to you. Some states do not
allowtheexclusion or limitation of incidental or consequential damages,
so the above limitation or exclusion may not apply to you.
Thiswarrantygivesyouspeci¿ clegal rightsandyoumayalsohaveother
rights which vary fromstate to state.
TROUBLE SHOOTING GUIDE
1. Repair or replace inlet line, make sure ¿ttings are air tight, use
T efÀ on
2. Tighten ¿ ttings air tight, use T efÀ on
3. Straighten hose
4. Submerge inlet hose end
5. Clean inlet
6. Lower pump
7. Remove blockage
8. Replace seal
1. If blown, replace with proper sized fuse or reset cirtuit breaker
2. If voltage is under 108 volts, check wiring size
tape if necessary
®
tape if necessary
®