Simeon Audita Manual De Usuario página 3

Simeon Audita Portable Soundfield Receiver
Figures 1 & 2
1
10
9
8
7
6
2
1. Power ON/OFF switch
with power indicator
2. Display Screen
3. Volume Control
4. Set Button
2
5. Cursors
6. Power adapter plug
(20V)
7. Speaker Output
8. Speaker Switch
3
9. Auxiliary RCA Input with
gain control
4
10. Voice Priority Button
11. Wall mount keyhole
12. Tone Control
5
13. AUX Out Gain
14. AUX Out Equalizer
15. Battery Housing
16. Battery Status Indicator
11
12
13
14
15
20%
50%
80%
100
%
16
Setup
Carefully unpack the soundfield system and separate its components.
Simeon Audita Portable Soundfield Receiver
Your Audita System includes either a dual-digital or a dual-FM receiver
module, to be used with the corresponding Simeon transmitters. It also includes
an integrated speaker, and multiple inputs and outputs. It is at the core of the
entire sound system.
It is recommended that you charge the receiver fully before its initial use.
Identify the correct power adapter for the receiver. Caution: never use non-
standard power adapters to charge your system. Plug in the receiver to charge
the battery [6]. Make sure the receiver is OFF while it is charging [1]. It may take
up to 16 hours for the receiver to fully charge. The battery status indicator [16]
will scroll through its coloured lights during charging. A continuous green light
indicates when charging is complete.
The Transmitter and Receiver channels on both the Audita Digital and Audita
FM Systems will have been assigned before shipping. It will only be necessary to
change the channels if the preassigned channels conflict with other FM or Digital
systems in your facility.
OPTIONAL Omnipanel Flat-panel Loudspeaker The optional Omnipanel speaker gives great acoustic performance and
outstanding speech intelligibility in a small, efficient format. The flat panel
speaker can be mounted almost anywhere, and be easily connected to the
system when you need the additional performance of an installed system.
If useful, the Omnipanel speaker can either be set up on a tripod floor stand
or it can be wall mounted. Simply slot the Speaker Mount [21] onto the top of
either the Floor Stand or the Wall Mount after they are in place. Tighten the
Fastening Knob [20] to ensure the safety of the Omnipanel. Make sure not to
over-fasten the knob, as this may cause damage to the Floor Stand or the Wall
Mount. Use only the included Speakon cables to connect the Omnipanel to the
receiver. Connect the cable into back of the Omnipanel [17] and rotate it to the
right to lock it in place. Do the same on the side of the receiver [7]. IMPORTANT
Move the Speaker Switch [8] to the "External Speaker" setting to transfer sound
from the internal speaker to the Omnipanel. To unplug the cables pull down on
the Speakon "Quick Lock," rotate the cable to the left and disconnect it. Be sure
to move the Speaker Switch back to the "Internal Speaker" setting when you no
longer want to output sound through the Omnipanel.
3