Idiomas disponibles

Idiomas disponibles

Enlaces rápidos

PLEASE READ ENTIRE INSTRUCTIONS BEFORE PROCEEDING.
IMPORTANT: Save these instructions for the Local Electrical Inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for the owner.
SAFETY WARNING: Before servic-
ing or cleaning unit, switch power off
at the service panel and lock service
disconnecting means to prevent
power from being switched on acci-
dentally. When the service discon-
necting means cannot be locked, at-
tach a tag to the service panel to
indicate power has been switched off
for maintenance.
WARNING - TO REDUCE
THE RISK OF FIRE, ELECTRIC
SHOCK, OR INJURY TO PER-
SONS, OBSERVE THE FOL-
LOWING:
Recommended for use only over conventional domestic gas and electric ranges, and
I. INSTALLATION:
1. Remove and discard shipping bracket (attached to mo-
tor mounts and inlet collar). Check to see if blower
wheel turns freely. Do not replace top until installation
is complete.
2. Provide a square cutout through the roof (or wall) as
shown by the dashed lines, or cut a round hole to fit duct
with a separate hole for electrical conduit as shown by
solid lines in Fig. 1.
3. Install the remote ventilator with the discharge pointing
down slope as shown in Figures 3 and 4. Follow standard
roofing procedures. Install the ventilator so the dis-
charge edge is on top of the shingles and the rear edge
is underneath the shingles.
OWNER: Please retain these instructions for future reference.
IMPORTANT SAFETY INSTRUCTIONS
A. Installation work and electrical wir-
ing
person(s) in accordance with all
applicable codes & standards, in-
cluding fire-rated construction.
B. Sufficient air is needed for proper
combustion and exhausting of gases
through the flue (chimney) of fuel
burning equipment to prevent back
drafting. Follow the heating equip-
ment manufacturers guideline and
safety standards such as those pub-
lished by the National Fire Protec-
tion Association (NFPA), and the
American Society for Heating, Re-
frigeration and Air Conditioning En-
READ AND SAVE THESE INSTRUCTIONS
use with an approved Thermador Hood.
INSTALLATION INSTRUCTIONS
ROOF OR WALL VENTILATOR
MODEL VTR1400Q, VTR1000Q & VTR600R
must be done by qualified
Fig. 1 TOP VIEW Down Slope of Roof or Wall
Model
VTR600R
VTR1000Q 7-1/4"
VTR1400Q 7-1/4"
1
gineers (ASHRAE), and the local
code authorities.
C. When cutting or drilling into wall or
ceiling, do not damage electrical
wiring and other hidden utilities.
D. To properly exhaust air, be sure to
duct air out side. Do not vent
exhaust air into spaces within walls,
ceilings, attics, crawl spaces, or ga-
rages.
WARNING: To reduce the risk
of fire, use only metal ductwork.
CAUTION - For General Ventilat-
ing Use Only.
Do Not Use To
Exhaust Hazardous Or Explosive
Materials And Vapors.
Dim.
A
B
C
5-11/16" 6-1/8"
9"
6-15/16" 11"
6-15/16" 11"
loading

Resumen de contenidos para Thermador VTR1400Q

  • Página 9: Instrucciones Importantes De Seguridad

    LEA Y GUARDE ESTAS INSTRUCCIONES Se recomienda el uso sólo encima de estufas eléctricas o de gas domésticas convencionales, y se debe usar con una campana aprobada por Thermador. Fig. 1 VISTA SUPERIOR Pendiente del Techo o Pared I. INSTALACIÓN: 1.
  • Página 10 8 pulg. de diámetro para VTR600R y un ducto con10" eléctrico a la caja de pared. Vea la Figura 8. de diámetro para VTR1000Q y VTR1400Q. Use codos ajustables para ajustarse al ángulo del techo. Aisle todas 4. Ponga el conducto eléctrico de acuerdo al código local a la las juntas con cinta para evitar fugas.
  • Página 11 Modelos CTR3Q o SSC1C (VTR600R solo) (no incluido) (no incluido) Fig. 8 VTR600R/VTR1000Q/VTR1400Q: DIAGRAMA DE CONEXIONES PARA MONTAJE EN PARED DEL REGULADOR DE CUATRO (4) POSICIONES, MODELO # CTR3Q blanco (común) motor de blanco (común) interruptor...
  • Página 12 BSH se reserva el derecho de modificar las especificaciones o el diseño sin previo aviso. Algunos modelos están certificados para ser usados en Canadá. BSH no es responsable de productos que son transportados desde los Estados Unidos para ser utilizados en Canadá. Consulte a su distribuidor local en Canadá. Para recibir la información más crítica con respecto a las dimensiones de instalación por fax, utilice su fax y llame al 775/833-3600.

Este manual también es adecuado para:

Vtr1000qVtr600r