Remote Control Tv Setting - Galaxy Innovations ST9195 Manual Del Usuario

6.2 Remote Control TV Setting

6.2.1 Programing the Remote Control
There are two ways to program the remote control ; Automatic Code Search or Direct Entry.
6.2.2 Using Automatic Code Search
1. Turn on the component(TV) you want to control.
2. Press and hold the TV button until the LED on the remote control turns on, then release the key.
3. Point the remote at the component(TV), press and release the UP button, then wait three seconds or until the LED stops flashing.
At this point the remote control is searching for the correct code to program.
If, after three seconds, the component(TV) you want to control does not turn off, press and release UP button again to tell the remote
to search the next set of codes.
Continue pressing and releasing UP button until the component turns off.
4. If the component you want to control does turn off ;
Press and release OK button, then the LED blinks three times.
6.2.3 Using Direct Entry Method
1. Turn on the component(TV) you want to control.
2. Locate the enclosed Code List. Find your brand of the component you want to control.
3. Press and hold the TV button until the LED on the remote control turns on, then release the key.
4. Enter 3-digit code from the code list, then the LED blinks three times.
5. If you get no reponse, repeat these steps using the next code listed for your brand until the component reponds to the remote control
command.
6.2.4 Changing Volume Lock
Locking the volume controls to a single device makes it easier to control volume, without having to guess whether the volume will
change. If you lock the remote's volume controls to the TV, you will always be able to change the volume to the level you want, without
having to adjust it on multiple devices.
If you wnat to lock the volume for the TV system ;
1. Press and hold the STB component key until the LED on the remote control turns on.
2. Enter 3-digit code, 9 9 9.
3. Press and release the STB component key, then the LED blinks three times.
Unlocking volume control ;
If you want to unlock the volume for the STB component ;
1. Press and hold the STB button until the LED on the remote control turns on.
2. Enter 3-digit code, 9 9 9.
3. Press and release the STB component key, then the LED blinks three times.
34
MANUAL_GI ST9195_9196_Eng_091127.indd 34 2009-11-28 1:59:52