Installing The Microphone - N-Com mcsIII S Serie Manual De Instrucciones

EN
Fig. 5
3.1.

Installing the microphone

JET HELMETS OR FLIP-UP HELMETS
 Prepare the microphone by inserting the microphone clamp, being careful to position it properly
(Fig. 6).
 Position the microphone in its support as shown in figure 7. Make sure that the side of the
microphone support with the writing "N-Com" is facing inward.
 Insert screw in the microphone clamp; use the key to screw in the microphone securing screw to
the shell frame (Fig. 8).
Fig. 6
8
 Remove the right and left polystyrene cheek pads by gently
pulling them out of the helmet. The helmet shell can be opened
slightly to facilitate the removal of the cheek pad.
Caution: In case the polystyrene cheek pad is damaged during
this operation, turn to your local dealer for its replacement.
Fig. 7 Fig. 8