Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Product Assemblies
SP-PNP-11-FN
SP-PNP-20-FN
Fully extend slides. Mount 1 – left hand
1
slide and 1 – right hand slide to the bottom
slide mounting holes in the upright brackets
using 8 – #6-32 X 5/16" screws. Repeat this
process for upper slides (1).
NOTE: There are 4 upper rack mounting
locations. Install upper slides at desired height.
Attach rear slide brackets to upper slides
2
by pushing bracket firmly onto slides (2).
NOTE: No rear slide brackets are needed
for lower slides.
Place slide and upright bracket assembly
3
into cabinet so that the front edges of the
slides are flush with the front of the cabinet
opening on the opposite side of cabinet door
hinges. Extend the upper drawer slide.
Pullout Cookware Organizer
Inspect all parts and read all instructions prior to beginning assembly and installation.
Tools Required
• Phillips Head Screwdriver
• Tape Measure
Parts Included
Upper Rack (1)
Lower Rack (1)
Upright Brackets (2)
1
If a half shelf is
present in cabinet
mount the rear
upright bracket
here.
2
Installation Instructions
Left Hand Slides (2)
Cross-Brace (1)
Rear Slide Brackets (2)
Cookware Dividers
Right Hand Slides (2)
Support Bar (1)
Left Slide
#6-32 x 5/16" Screws (18)
#8 x 3/4" Wood Screws (4)
#6 x 1/2" Wood Screws (7)
SP-PNP-11-FN (4)
SP-PNP-20-FN (5)
Right Slide
3
Flush
Manuales relacionados para simplyput SP-PNP-11-FN
Resumen de contenidos para simplyput SP-PNP-11-FN
- Página 1 #6-32 x 5/16" Screws (18) #8 x 3/4" Wood Screws (4) Lower Rack (1) Rear Slide Brackets (2) Cookware Dividers #6 x 1/2" Wood Screws (7) SP-PNP-11-FN (4) SP-PNP-20-FN (5) Upright Brackets (2) Right Hand Slides (2) Support Bar (1) Product Assemblies...
- Página 2 Push the slide back so that the mounting hole is accessible. Install 1 – #6 x 1/2" wood screw (4). Ensure that upright brackets are parallel to the front of the cabinet then attach to the base of the cabinet with 4 – #8 x 3/4" wood screws (5A).
- Página 3 Tornillos para madera Estante inferior (2) Separadores de utensilios deslizantes (2) #8 x 19 mm (3/4") (4) de cocina (5) SP-PNP-11-FN (4) Tornillos para madera SP-PNP-20-FN (5) Soportes verticales (2) #6 x 12.7 mm (1/2") (7) Guías deslizantes Assemblages Ensamblaje...
- Página 4 Empuje la guía deslizante hacia atrás, de manera que pueda acceder al orificio de montaje. Coloque 1 tornillo para madera #6 x 12.7 mm (1/2") (4). Asegúrese de que los soportes verticales están paralelos a la parte frontal del armario cuando los una a la base del armario con 4 tornillos para madera #8 x 19 mm (3/4") (5A).