Tyco Electronics RECORDsplice RPI-SA100 Instrucciones De Instalación página 9

7.4.3 Guide the prepared fiber
configuration through the front fiber clamp
(9) and through the fiber entrance hole (11).
Insert and push until it goes no further (the
fiber will buckle and the finger tips will touch
the fiber holder). Maintain the buckle while
closing the front fiber clamp (9) by hinging
the fiber clamp lever (10) in position III. If the
fiber can not be inserted in the fiber entrance
hole (11), follow instructions in section 8.2.
7.4.4 Bend the fiber over the fiber holder.
Clamp the fiber in the back fiber clamp (12)
by hinging the fiber clamp lever (10) in
position IIII.
7.4.5 Turn the program control in position 2 .
Cleave status is marked in cleave control
window (13). The cleave is OK when the red
indicator is in the OK position and the
program controller (2) in position 2 .
In case of error: follow instructions in
section 8.3.
9