Carburetor Adjustment; Regular Maintenance; Air Filter - Maruyama BC2259 Manual Del Propietário

CARBURETOR ADJUSTMENT

The carburetor has been carefully adjusted at the factory and should not
require any further adjustment. Only the idling speed can be adjusted by
turning the idle speed adjustment screw (see sketch). The correct speed
for model BC2259, BC2259H and BC329H are 2700 - 3300 RPM, and for
others are 2400 - 2800 RPM (or just below the clutch engagement speed).
Turning the adjustment screw clockwise will increase the idle speed.
If further adjustment is necessary, please contact a local authorized
MARUYAMA dealer.
OPERATING THE BRUSHCUTTER
MARUYAMA brushcutters are designed and tested to cut nearly all grasses, thick weeds and brush. As you
continue to use the equipment, many tasks will become easier.
CAUTION-Read the SAFETY INSTRUCTIONS concerning the proper use of the brushcutter on page(US-1).
CAUTION-Observe all warnings that appear on the brushcutter.
CAUTION-Use only the correct blade approved for the task and the machine.
CAUTION-Always use the Shoulder Strap or Shoulder Harness when operating a brushcutter with a metal blade.
The brushcutter must be positioned to the right side of the operator when used with a metal blade.
CAUTION-Always make certain the blade is installed to rotate in the proper direction and that all holding and
fastening parts are correctly secured.
CAUTION-Remove the holding tool ( φ 3.5 or φ mm pin) before operating the equipment!
CAUTION-Do not continue to use a blade that is dull, damaged, or that vibrates during use. Whenever a cutting blade becomes clogged with debris, immediately stop the machine and clean the blade.
CAUTION-When cutting heavy brush or small trees, use the proper method to avoid dangerous " KICK-BACK
"(see sketch).
No Kick-back Zone
CORRECT

REGULAR MAINTENANCE

AIR FILTER

The air filter should be cleaned each time the brushcutter is used. (Or more often with extreme conditions.)
Remove the filter cover and take out the element. Wash the element in kerosene or warm detergent, then squeeze
it dry. Apply oil (#30 wt.) to foam, removing all excess oil. Assemble and reinstall the element and filter cover.
Filter Cover
Screw
Foam Element
[BC2259, BC2259H]
Direction
Direction
of Motion
of Motion
INCORRECT
Filter Cover
Foam Element
[BC329H]
— US-6 —
Idle Speed Adjustment Screw
Increase
Decrease
DANGER
Kick-back Zone
Filter Cover
Foam Element
[BC429H, BCF429H, BCF509H]