SATA AE1021 Manual Del Uso página 58

3.3 Tire installation
- The most important thing is to check the tires and rims to prevent explosion during inflation. Before starting the installation operation,
ensure that: Check whether the tire and rim are of the same size, and whether the tire and tire tread fiber are damaged. If so, do not
install the tire. Whether there are dents and warpings on the rim, pay attention to whether there are any tiny scratches on the inner side
of the aluminum alloy rim, which are dangerous, especially during air inflation.
- Do not put your hand between the rim and the claw in the process of clamping the rim to avoid personal injury!
- When the rim is locked, do not put your hands under the tire. The correct operation is to locate the tire in the center of the crankset.
- Place the tire obliquely on the rim (left high and right low), and press down the hexagon shaft to make the mounting head abut against
the rim and lock it. The left rear tire bead is placed above the tail of the mounting head, and the right front tire bead is placed below the
head end of the mounting head. Press the tire opening into the groove of the rim by hand. Step on the pedal to cause the crankset to
rotate clockwise. Continue this operation until the tire is fully loaded into the rim.
- In order to prevent work accidents, keep hands and other parts of the body as far away as possible from the tire dismounting arm when
the crankset rotates.
- If there is an inner tube, install it in the tire and penetrate the valve core. Install the upper tire bead according to the previous step.
- When dismounting and mounting tires, the crankset shall rotate clockwise. Counterclockwise rotation is only used for error correction
when the machine is stuck and causes the operator's error.
58
AE1021/AE1021-3/AE1021H/AE1021H-3
中文
EN DE RU KO PT JA ES