Removal From Window - Kenmore 580. 74109 Manual Del Propietário

HIF AIR CONDITIONER IS BLOCKED BY
STORM WINDOW FRAME
• If storm window presents interference, fasten a 2"
wide wood strip to the inner window sill across the full
width of the sill. The wood strip should be thick
enough to raise the height of the window sill so that
the unit can be installed without interference from the
the storm window frame. See FIG. 11.
Top of wood strip should be approximately 3/4"
higher than the storm window frame to help
condensation to drain properly to the outside.
• Install a second wood strip (approximately 6" long by
11/2" wide and same thickness as first strip) in the
center of the outer sill flush against the back of the
inner sill.
• Air conditioners covered in this manual pose an
excessive weight hazard. Two or more people
are needed to move and install the unit.
To prevent injury or strain, use proper lifting and
carrying techniques when moving unit.
• When handling the air conditioner, be careful to
avoid cuts from sharp metal fins on front and
rear coils.
• Make sure air conditioner does not fall during
removal.
WOOD STRIP 1 112" min. 3t4"(19mm)
MOc T Os ,TOPCLEARANCE
STORM
V//////////dz//_ WINDOW
V/,F.®R:SU,_P,O_.T_/A 't
OUTtR
INDOO__ _!_DOOR
When storm window
frame is located on outer sill
FIG. 11
REMOVAL FROM WINDOW
• Turn off and unplug the air conditioner.
• Unscrew the side screws that you installed in Step 5.
• Close the curtain frame and remove foam seal and L
bracket from the windows.
• Keep a firm grip on the air conditioner and raise the
sash.
• Lift the air conditioner from the window.
• Remove the foam strip from between the window.
• Remove the support bracket from window frame.
• Place unit and mounting hardware in air conditioner
shipping carton, and store in clean, dry pIace.
-8-