Tabla de contenido
Instalación y configuración del sistema
11. Slide the contol panel cable tab into the slot at
the bottom left of the unit.
12. Connect the control panel and power cables as
shown.
13. (DMS 815 Only) Attach the Annotation Pod
as shown on pages 8–9 of the Digital Media
System 815 eBeam Software for Interactive
Whiteboard Operator's Guide.
14. Start up the projector.
15. Adjust the projector arm length to achieve the
desired image size. Extend the section of the
arm closest to the base first by loosening the
clamp, sliding the arm out, and tightening the
clamp. Extend the second section of the arm as
needed.
16. Focus the image by turning the projection focus
ring.
17. To adjust the position of the image on the
screen, refer to the Digital Media System 800
Series Image Alignment Guide.
46
DMS serie 800 de 3M™
Extend this section first
Extend this section last
Projection Focus Ring
© 3M 2006. Todos los derechos reservados.
Tabla de contenido
