Tabla de contenido
Idiomas disponibles
Idiomas disponibles
EN
16
Using the device for wet and dry vacuuming
•
Fit the blanking plug (5) at the outlet of the collecting vessel.
•
For wet vacuuming: Fasten the filter sponge for the motor (13) (see pond
and pool vacuuming device).
•
For dry vacuuming: Fasten the paper filter bag (15) to the inside of the
upper opening of the collecting vessel.
•
For switching on the device, turn the switch (2) to I, MANUAL. In this
position, the device operates continuously in continuous operation
without interval switching.
•
Check the filling level of the collecting vessel from time to time and, if
necessary, empty or replace it.
•
Switch off the device after use (0), pull out the net plug and clean collecting
vessel as well as filter inserts.
Switching/Operating Modes
Switch position 0
Motor off
Switch position I
Manual operation (ON/OFF) for wet/dry vacuuming operation
Switch position II
Automatic operation for pond and pool cleaning
•
After switching on, the motor will suck for 30 seconds.
•
b) Motor stops after approximately 30 seconds to drain.
•
Auto Start after 30 seconds.
•
Repetition (a) and (b) to OFF (0).
CLEANING AND CARE
•
Thoroughly clean the collecting vessel and dirt collecting bag (4) with
water and, possibly, with a little mild household cleaner.
•
Check suction hose (9), suction tubes and drain hose (3) occasionally for
possible blocking or dirt residues and remove them.
•
Carefully wash the filter sponge for the motor (13) with water and.
possibly, with a mild household cleaner and dry it afterwards.
Tabla de contenido
