Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation
1
Installing the doorbell
Plug in the doorbell (A) at the desired location.
2
Removing the battery tab
Remove the back of the push button (B) by
pushing in the tab on the bottom with a small
screwdriver (not included).
Remove the orange battery tab from the push
button (B).
Testing the push button and
3
doorbell
Temporarily position the push button (B) where
it will be mounted.
Press the push button (B) to verify the
doorbell (A) and push button (B) work properly.
If the doorbell (A) does not sound, move the
doorbell (A) closer to the push button (B) and
test again.
NOTE: Do not permanently mount the push button until
the push button and doorbell are working properly.
4
Mounting the push button
Use either screws (BB) or double-sided tape (CC) to
mount the push button (B).
To mount with screws (BB), remove the back
of the push button (B) by pushing in the tab on
the bottom with a small screwdriver. Place the
push button back on the door jamb and mark
the two screw holes. Drill two 1/16 in. pilot
holes. Attach with screws (BB) and snap on the
front of the push button (B).
When attaching the push button (B) with
double-sided tape (CC), remove the paper from
both sides of the double-sided tape (CC) and
apply to a clean surface.
NOTE: The push button and doorbell come synced from
the factory. The range of the wireless doorbell can vary
with location, temperature, and battery condition.
B
NOTE: Remove material in screw holes (if needed) before
mounting with screws.
BB
5
Please contact 1-844-760-3644 for further assistance.
A
B
A
HAMPTONBAY.com
Capítulos
Tabla de contenido
