Tabla de contenido
Idiomas disponibles
Idiomas disponibles
OPERATION
1
Check if the water reservoir is correctly
2
When the plug is inserted into the mains, the led
3
To turn the equipment on, press the button
4
When pressing any button, a signal will be emitted. The equipment starts to
dehumidify. The compressor automatically turns off when the water reservoir gets
While the water reservoir is not full, the equipment will continue operation until it is
turned off manually or until the relative humidity selected by the user is reached. The
compressor will start three minutes after the power is turned
5
To turn the equipment off, press the button
The minimal operating condition for dehumidification is at least 17°C to 50% relative
humidity. Under this, the equipment can work up to 8°C, but there will be loss of
dehumidification efficiency.
WATER DRAINAGE
If you prefer, it is possible to connect the drain hose to the equipment to drain the water
permanently. Simply connect the drain hose (not included) to the drain spout and make
sure that the hose tip it stays lower than the drain opening. When you no longer want
to use permanent water drain, disconnect the hose from the equipment. Make sure that
the water tank is correctly positioned.
CLEANING
Turn the dehumidifier off and remove the plug from the electric network before starts
cleaning.
EXTERNAL PART
Wipe the external with a soft and dry cloth. If the equipment is extremely dirty, use a
mild cleaning agent. Clean it with a slightly damp soft.
AIR FILTER
When used regularly, the filter can become dirty with dust and particles in suspension,
so it should be cleaned every two weeks or as needed.
docked.
When the water reservoir gets full:
- A signal will be emitted.
- The compressor automatically turns off and the
dehumidification process stops.
- Drain out the water reservoir and fit it into the right
position. The dehumidification will start immediately
after the replacement.
22
will blink
intermittently.
ON/OFF.
on.
ON/OFF.
full.
Tabla de contenido
